How To Install Good Sound And Power Bass In A Car Stereo
The purpose of a subwoofer is to add some bass to the audio that is played in the stereo. An already existing factory stereo can be made to play powerful music by adding subwoofer to it. By following these guidelines on how to install a subwoofer in a factory stereo, the installation can be done with little or no help from a professional.
To do the installation of the subwoofer, a wiring kit for amplifier, harness adapter, screwdriver, tool for the removal of the panel, drill, wires, wrench and grommets made of rubber.
The battery of the car is disconnected till the installation is done. The negative terminal cable is removed from the terminal. A screwdriver or an appropriate wrench can be used to loosen it. A ring terminal is attached between the power cable and positive terminal of the battery. The cable for power supply is routed between the compartment where engine is kept and the vehicle’s inner cabin. There is generally an aperture for the wire but if there is no such facility a hole can be drilled and use a grommet for protection.
From the end of the wire the insulation is stripped off. The exposed ends are elongated a little bit than the metal portion so as to enhance a connection with the crimp connector. the wires are crushed with a finger to make it straight so that it goes into the connector properly and gets connected firmly. This will make the process of insertion easier.
Next step is the most important one. It is the installation of line out converter. It is also called as LOC. Locate the factory speakers. This is found inside the car trunk. Many wires are connected to the speakers . Now with cutting pliers disconnect one of these wires. However ensure that there is provision for reconnection of this wire. The line out converter is now fixed to the wiring . Next step is reconnection to that speaker (6×9) .
The line out converter is successfully installed . We now need to understand what is the function of this. This LOC eliminates the need for replacement of head unit of factory as it enables the connection of RCA cables with our amplifier. For safety purposes grounding should be done. So locate a bolt made of metal. Connection is made between ground wire of the amplifier and metal bolt.
The stereo is then replaced back in the dashboard of the car. Then the battery is reconnected by placing back the negative terminal cable on the negative terminal. The clamp can be tightened with the help of a screwdriver or a wrench.
One should always know How to Install a Sub woofer in a Factory Stereo , as it is one of the most important tool.
Want to find out more about , then visit Author Name’s site on how to choose the best for your needs.
Related posts:
- Helpful Tips For A Volvo Stereo Install It is a clich that installing radios and stereo in...
- Painless Wiring, Connect An Car Amp With A Cable Kit Easily How to Install an Amp Kit? Amplifier wiring is a...
- Helpful Tips To Wire A Amp To A Car Radio The two main factors affecting the performance of a audio...
- Make A In-Dash CD/MP3 Player Mounting Easily If your car still has the cassette player than you...
- Replacement Car Spears Are Easy To Install Replacement car speakers are a must if you're an avid...
Related posts brought to you by Yet Another Related Posts Plugin.